www.letmodel.cz | to bookmark's | home page

SLS 22


SLS 22 setup information
TECHNICAL INFORMATIONS SLS-22

Motor Torcman PM430-20-10-Super-Chief 5:1(go to web info Torcman)

Torcman PM430-20-01 Torcman PM430-20-02
8 - 12 Lipos , The PM430-20 can go upto 2500Watts

Propeller APC 22x10

Propeller RASA carbon 22x10

APC propeller 22 RASA carbon propeller 22
Weight of the APC propeller is 120 gWeight of the RASA propeller is 92 g
Servo Hitec HS 7950 TH Servo HS7950 TH
Datasheet HS 7950 TH
JETI SPIN 99 OPTO
JETI SPIN 99 opto
Manual for controllers SPIN - EN
videoVideo section
Flying weight Ventus 2cx is 14,3 kg
Video:Ventus 2cx with SLS-22 in Jesenik airport
" Ventus 2cx with SLS-22 in Jesenik airport"(wmv 11,9 Mb)

SNOW? No problem for us !!!
Video:SLS - flight with camera on the board
" SLS - flight with camera on the board"(wmv 10,1 Mb)
Video
"Test flights in Switzerland"
(mpeg 33,7Mb)
Video
" Locked SLS in flight mode"
(wmv 0,9Mb)
Pictures real glider ASH 26 with motor system

However we introduced SLS-22 LET MODEL in Ventus 2cx,
the design was inspired by original motor system of full size glider ASH 26...

ASH 26 M - full size glider ASH 26 M - full size glider
ASH 26 M - full size glider ASH 26 M - full size glider
ASH 26 M - full size glider ASH 26 M - full size glider
ASH 26 M - full size glider
SLS 22 new generation SLS 22 open and shut position Ventus 2cxM D-KGUY

ASH 26
Double doors for SLS 22
ASH 26
Simple doors for SLS 22
Ventus 2cxM D-KGUY

The doors - one servo solution
One servo solution

The doors - one servo solution
One servo solution
The doors are with carbon reinforced, with two servos solution
ASH 26
SLS door servo is
SS 1816 TOPMODEL CZVentus 2cxM D-KGUY
...or
Hitec HS-82 MG
ASH 26
Hitec HS 7955 TG or Becker servo S2000
Ventus 2cxM D-KGUY
 carbon-reinforced doorVentus 2cxM D-KGUY
Ventus 2cxM D-KGUY

Pictures section
SLS 22 SLS 22 SLS 22
SLS 22 SLS 22 SLS 22
SLS 22 SLS 22 SLS 22
SLS 22 SLS 22 SLS 22
SLS 22 SLS 22 SLS 22




Three versions of motor fusselage

Factory LET would like to show you some pictures from different versions of motor fusselage.

1. SLS 22 LET version is detailed above...
         
pdfHere you can see what is " installation of the unit"

Three M versions Three M versions Three M versions Three M versions Three M versions Three M versions Three M versions

2. Elicker system you can see here...

     pdf download PDF document with the pictures of the "Elicker system" installation
....go to web site Markus Elicker

3. AFT 19 motor system

AFT 19 AFT 19 AFT 19 AFT 19 AFT 19

Ventus + AFT 19 Comment of the pilot
...The maiden flight of LET Ventus 2cM with an AFT19 X from Florian Schambeck and 10s1p Lipos. After I flew the Ventus for more than two years now (I bought it from Ueli Nyffenegger), I decided to mount a retractable engine because I was so satisfied with the flight characteristics of the Ventus and I wanted to be more independent from any towing planes. What should I say, the power was quite enough to start from our very short airfield (~100m) and climb rate was ok. The additional weight to the former 12.5kg is about 2kg and will be even less (~1.3kg) when I will replace the steel bar by one made of CFK in a steel tube.
(Wolfram Just-Germany)

Ventus + AFT 19 Ventus + AFT 19 Ventus + AFT 19

.... go to web site Schambeck Luftsporttechnik

««« back

 
::